🎿 Fixing A Leaking Toilet Cistern

Turn off the toilet shut-off valve and flush to empty the tank. Use a bucket to remove any remaining water in the bowl. Apply lime and rust remover gel liberally into the bowl and trapway. Let sit 15 minutes. Scrub the bowl with a toilet brush to agitate the cleaner. Flush the toilet 2-3 times to rinse thoroughly. Remove lid from tank. Shut off water by turning the shut-off valve clockwise. Drain as much water out of tank as possible by holding flush lever down until toilet is completely flushed. Sponge or towel out any remaining water in the tank. A shop vac also works well. Disconnect water supply tube or hose to tank. 4. Phantom Flushes. Phantom flushes can also be both eerie and wasteful. This phenomenon occurs when the toilet seems to flush on its own. The usual cause is a slow leak from the cistern into the bowl, often due to a defective flapper or seal. Replacing these parts can typically solve the problem. 5. DO NOT use a metal washer directly under the bolt head inside the tank, as this will cause a leak. For Kohler 3-bolt tanks, Fluidmaster recommends that you use Kohler’s triangular tank to bowl gasket and bolt kit. To download our free guide to fix common toilet problems please click here: Fluidmaster Toilet Repair Guide Replacing the toilet tank to bowl gasket because of leaks are rare, but toilet gaskets do dry out and crack over time that leads to water leakage on to the f Make sure the toilet tank is filled with water. Flush the toilet. Check if the water is coming out of the base during flushing. If not sure, you can add food dye to the flushed water so you can trace it more easily. Check if there’s water left at the base of the toilet after the flushing is over. If your toilet was installed with silicone, to fix the leak is actually a lot easier. The pan can be removed by cutting around the base of the toilet and once it is loose it can be removed. This gives access to the pan collar. Leaking seals can then be replaced and then the pan can be reset. Replace the tank on the bowl. Alternating side to side, tighten the bolts and nuts (using the screwdriver and adjustable wrench) until the gaskets look like they’re seated. Remember: When reattaching the tank to the bowl, don’t over tighten the bolts that secure the tank to the toilet base or you can easily crack the tank. Remove the tank lid, then flush. Wait for the flapper/tank ball to drop and the tank to refill. Add a few drops of food color or place a colored dye tablet, available at hardware stores, after the toilet has stopped filling. Wait at least 20 minutes. If any trace of the color appears in the toilet bowl then there is a leak. Bolt through fixing kit for securing cistern to toilet pan. Leaking Incoming Supply. Again if this is a newly installed toilet and you have just noticed a puddle of water on the floor then it may be coming from the incoming water supply and where it’s attached to the toilet fill valve or flush valve as it’s also known. STEP 5: Turn on the water and test for leaks. After replacing the toilet flapper, check to make sure the chain is the right length. It should sit at a relaxed length, with a small amount of slack ITEMS I USED YOU CAN BUY HERE:- Tank To Bowl Bolt and Gasket Kit - bbaj.

fixing a leaking toilet cistern